| 1. | Maximum stress theory
最大应力理论 |
| 2. | Because of high sharp peak , vibration stress is big , and the maximum stress achieves 550mpa
由于油缸冲击载荷有比较大的峰值，泵车动应力比较大，最大值达到550mpa 。 |
| 3. | The result indicates that the maximum stress on the runner is mainly in proportion to the turbine output
结果表明在大部分工况下该转轮叶片最大静应力基本上与水轮机功率成线性关系。 |
| 4. | The maximum stress was on the apices and the stress on the cervical part was lower
种植体应力主要为均匀分布的压应力，最大应力位于种植体根尖部，颈部应力相对较小，未见明显弯曲应力。 |
| 5. | The mechanical simulation compared the stress distribution in copper lines and pore , with the result that the maximum stress locates in the corner
在力学模拟过程中，计算了铜互连线和通孔的热应力的分布。 |
| 6. | The results are that the maximum displacement and maximum stress occurs at initial time and the maximum stress is less than permissible stress
结果表明,结构最大应力和最大位移均发生在初始时刻,最大应力小于许用应力。 |
| 7. | By analyzing the optimal diffluent ratio and solder angle of the dies , the maximum stress in the body of improved dies is de - creased effectively
对模具的分流比和焊合角进行优化并再次模拟，发现分流模的最大应力大大降低。 |
| 8. | The stress of horizontal working states is bigger than others , and the maximum stress attaches to 540 mpa . only considering static strength , the bump auto satisfies command
水平工况应力较大，最大应力为540mpa ，单从静强度方面考虑，该泵车满足强度要求。 |
| 9. | Using the library functions of msc . patran language the stresses of structural elements is picked up , and the maximum stress of the elements controlled by the same design variable is found
利用msc . patran的库函数，提取结构单元的节点应力，通过循环找到构件的最大应力。 |
| 10. | 2 the maximum stress and the maximum stress location and the distribution of the stress are attained through the static analysis of building up finite element module
2 、对建立的有限元模型进行静强度分析，得到各个工况该泵车的最大静应力值和最大静应力位置及各构件的静应力分布。 |
